700mm 5200w 400v 50hz log saw (CL700A)

Our log saw include electrical log saw and gasoline log saw.

Our wood saw is with 400mm blade, 600mm blade and 700mm blade.

Wood saw machine can cut firewood at any length.

Log saw for sale

Fire wood saw is made by us, 9.0hp firewood saw and 13.0hp firewood saw.

Our wood log saw can be color depending on client's order.

We can consider trial order of log saw cutting machine.

We make circular wood saw at high quality and short time of delivery.

Gasoline log saw / petrol log saw include 9.0hp and 13.0hp 700mm blade.

700mm 5200w 400v 50hz log saw

pure copper motor

log holding part is useful design

professional log saw

400v 50hz ce log saw

3phase log saw

CL700A

Motor: 400v/50Hz, 5200w, 1440r/min, IP54

Cutting diameter: 30~270mm

Blade: 700*30*3mm

N.W. /G.W.: 96.50kgs/106.50kgs/1pcs

Packing size ( LxWxH): 116*90*116.5cm/2pcs

Container loading: 48pcs/20ft, 104pcs/40ft

700mm 5200w 400v 50hz log saw  Operating Conditions

Machine cover is essential to minimize the injuries by flying broken blades.

Irrelevant people are not allowed in the work shop.

Flammables and explosives should be kept away from the work floor.

700mm 5200w 400v 50hz log saw Safety Measures

Wear glasses when working, to prevent from injuries by broken blades.

Watch out for your ties and sleeves. Long hair should be kept inside the cap, and no gloves are allowed during operation.

700mm 5200w 400v 50hz log saw  Before Use

Ensure the machines are in good condition with no deformation and no spindle vibration, the spindle's running tolerance can h7.

Make sure the blades are not excessively worn-out, blade body has no deformation or breaks lest 700mm 5200w 400v 50hz log saw injuries occur.

Make sure appropriate saw blades are used.

700mm 5200w 400v 50hz log saw Installation

Ensure the saw blade turns in the same direction as the spindle does. If not, accidents are likely to occur.

Choose the flange whose inner diameter is the same as that of the saw blade but the outer diameter is a little larger than 1/3 (for multi-rip saw blade is 1/2) of the saw blade. Ensure the flange is clean, not over worn, bent and distorted shape.

Check the tolerance between the saw blade and the spindle. Install the flange and fasten the screw.

Be sure no people stand in front of the machine when starting the machine. Do not feed, just to check whether there is a vibration, radial or axial run out.

Saw blade reprocessing such as bore trimming or re-boring, should be finished by the factory. Poor reprocessing would lead to poor quality and may cause injuries.

While installation, the saw blade should be 5-6 teeth higher than the board surface.

700mm 5200w 400v 50hz log saw In Use

In operation wood materials should be properly fixed lest abnormal cutting occurs.

The operation must be stopped rightly once unusual nose and vibration occurs, if not, rough surface and tip-breaking many occur.

700mm 5200w 400v 50hz log saw After Use

Saw blade should be re-sharpened because dull saw blades many affect cutting effect and lead to accidents.

Re-sharpening should be made by professional factories, not changing the original teeth angle degrees.